Array preconfiguration tasks
Before you configure a NetBackup policy, make sure that the following tasks have been completed.
Table: Array preconfiguration tasks describes the tasks.
Table: Array preconfiguration tasks
Array administration tasks | Where described |
|---|---|
Install the disk array and its software, including appropriate licenses. | See your array documentation. |
Install supported HBAs on the NetBackup primary client and alternate clients. | See your HBA documentation. |
Zone the client HBAs through the Fibre Channel switch, so the array is visible to the primary client and to any alternate clients. | See your Fibre Channel documentation. |
Install NetBackup, and array vendor snapshot management software, on the NetBackup primary client and any alternate clients. | See the appropriate installation documentation. |
Create and configure the Access Logical Drive for the host connection at the array. Configure logical drives on the array and make them visible to the host. | See your array documentation. |
More Information