Restoring a HP-UX client with media boot
Note:
Review the secure communication compatibility support matrix for BMR table to know more about the supported master, boot server, client, and SRT versions for Linux, Windows, Solaris, AIX, and HP-UX environments. See Secure communication compatibility matrices for BMR for NetBackup 8.1.1 and later releases.
Note:
If NetBackup access management is used in your environment, you must provide the appropriate credentials when prompted so that NetBackup can restore the client files.
To media boot an HP-UX client, do the following.
To restore a HP-UX IA client with media boot
- Prepare to restore the client using the SRT you created on the bootable media.
- Insert the bootable CD or bootable DVD into the CD-ROM drive.
- Boot the client to restore.
- In response to the Run a Recovery Shell prompt, type Yes.
- In response to the Start Networking prompt, type Yes.
- In response to the Choose the Network Interface prompt, type the default LAN device to boot from.
You must enter the default LAN because the firmware uses this address for booting from the Ignite server. Note that any network interface card can be used for accessing the SRT or backups, but the default LAN must be used for booting.
Enter the following information when prompted:
Hostname
IP address
Default gateway
Subnet mask
- At the Is this network information temporary prompt, type No.
- Use the arrow key to scroll to OK and press Enter.
- Due to the automatic recovery parameter set during prepare to restore, the restore operation attempts to retrieve the host-ID based certificate and validate the Certificate Authority (CA) certificate. This recovery is time bound. For more information about the automatic recovery during prepare to restore, See Preparing a client for restore.
Enter the required information at the following BMR process prompts:
Client name (for a discovery boot, enter the client's name as it appears in the Tasks view from the prepare-to-discover operation)
NetBackup master server name
NetBackup master server IP address
NetBackup master server gateway IP address
The restore begins.
Note:
If you abort the restore operation or if the restore operation fails, either run the prepare to restore operation again to restart the automatic recovery or manually set the Security > Host mappings > Hosts > Menu button > Allow auto reissue certificate option using the NetBackup web UI or command-line interface.
For more information about manually setting the Allow Auto Reissue Certificate option, see Allowing automatic reissue of a certificate section within the NetBackup Security and Encryption Guide
After a successful completion of restore, the host ID-based certificate is copied on the client that is restored. The automatic recovery parameter is reset. For more information about the automatic recovery, See Preparing a client for restore.
More Information