To use the Device Configuration Wizard

1. In the NetBackup Administration Console, click Configure Storage Devices in the right panel to launch the Device Configuration Wizard.
2. Click Next on the Welcome window. The Device Hosts window appears.
   
3. Under Device Hosts, put a check by the NetBackup media server that accesses the NDMP host.
4. Select the server name and click Change.
5. In the Change Device Host window, place a check beside NDMP server, then click OK.
   

   In the Device Hosts window, NDMP is now listed in the Optional Devices to be Scanned column for the media server.

6. Click Next to display the NDMP Hosts panel.

   Note:

   For a NetApp cDOT system, the NDMP host must be a cluster-management LIF. NetBackup does not support any other LIF type as the NDMP host name for storage device configuration.

7. To add a new NDMP host, click New. The following window appears:
   
8. Enter the new NDMP host name and click OK. The NDMP Host Credentials window appears.
   
9. Select Use the following credentials for this NDMP host on all media servers. Enter the User name and password for the desired NDMP filer.

   See About NAS appliances support. for information about supported NDMP operating systems and NAS vendors.

   The Scanning Hosts window appears. NetBackup scans the host to discover all attached tape and disk devices. When completed, the Scanning Hosts window looks like the following example:

   
10. Follow the remaining prompts in the wizard to complete the configuration.