Scanning the storage on the appliance
Use this command to scan the storage from each node (one at a time) for the appliance.
Warning:
Do not start the storage scan on the second node until the first has finished.
See How to configure the Access Appliance for the first time.
Note:
If the appliance has been re-imaged, you must perform a storage reset before you can perform this procedure.
To scan the appliance storage
- Log on to the Access Appliance shell menu of one of the appliance nodes.
- From the Main_Menu > Manage > Storage view, type the following command to scan the storage:
Scan
Wait for the Scan operation to complete on the current node.
- Repeat this procedure on the other node.