Setting up a NAS-Data-Protection policy
To set up a policy for NAS data protection
- Open the NetBackup Administration Console.
- Click NetBackup Management > Policies in the left pane.
- In the All Policies pane, right-click and create a new one.
- From the Policy type list, select NAS-Data-Protection
- From the Policy Storage list, select Storage Lifecycle Policy for backup from snapshots.
- The Perform snapshot backups option is selected by default.
- (Optional) Select the Take checkpoints every check box and enter a value in minutes.
- (Optional) To track changes between two snapshots, select the Enable vendor change tracking for incremental backups check box.
Note:
At a given time, you can only use either the Enable vendor change tracking for incremental backups or the Use Accelerator check-box.
- Click Options and set a value for the following parameters:
Snapshot Type
Snapshot Host
- In the Dynamic Data Streaming Attributes section, the Allow dynamic streaming option is selected by default. Configure the following attributes:
Note:
With this setting, the Allow multiple data streams option is also selected.
Maximum number of streams per volume
The number of streams per volume must be between 1 to 20. The default value is 4.
Maximum number of files in a batch
The number of files in a batch must be between 1 to 2000. The default value is 300.
- (Optional) Select the Use Accelerator check box.
Note:
At a given time, you can use either Enable vendor change tracking for incremental backups or the Use Accelerator check box.
- On the Schedules tab, set the required attributes for the schedule.
Note:
For Instant Recovery, only Snapshots and copy snapshots to a storage unit is supported and is selected by default.
- On the Clients tab, from the NAS Vendor list, select the preferred vendor.
- Click New to add a new client.
- On the Backup Selections tab, select the preferred protocol.
NFS
SMB
- (Optional) If you want to want to use volumes that support both NFS and SMB protocol, select the Include Mixed Volume check box.
- From the Backup Host Pool list, select the preferred pool and click New. If no backup host pools of the relevant type are available, you can see a dialog prompting you to create one, click Yes in the dialog to create one.
- In the Add Backup Selection dialog box, click Browse.
If you add a subdirectory from volume in the backup selection then the policy validation fails.
- In the NAS Assets Selection section, select the preferred volumes and click OK.
- On the Exclude Volumes tab, in the Volume to exclude field, add the preferred volumes that you don't want to backup.
- Click OK.
