Register NetBackup Enterprise Vault migrator
To manually register the NetBackup Enterprise Vault migrator installed by NetBackup
- Stop all Enterprise Vault services on all systems where Enterprise Vault is installed.
Start the service Control Manager.
Make a note of all of the Enterprise Vault services that are currently running. The names of the Enterprise Vault services begin with Enterprise Vault.
Stop all of the Enterprise Vault services.
- Register the new NetBackup 7.1 Enterprise Vault migrator module.
Open a Command prompt window.
Go to the NetBackup\bin directory.
Type the following command to register the NetBackup 7.1 Enterprise Vault migrator module, NBUMigrator.exe.
NBUMigrator.exe /RegServer
- Start the Enterprise Vault services that were stopped in Step 1.
After you have registered the Enterprise Vault migrator, Veritas recommends that you do the following:
Test your migrator configuration.
Set the recommended DCOM settings so the migrator runs under the proper user identity.
See Setting the recommended DCOM settings.
Veritas recommends that you review this topic irrespective of whether you have performed a manual registration or not.