Configuration requirements if using Change Server with NBAC or Enhanced Auditing
Additional configuration is required to perform the Change Server operation if NetBackup Access Control or Enhanced Auditing is used.
The following steps assume that NBAC or Enhanced Auditing is already configured.
Add fromServer to the host properties Additional Servers list on toServer.
If fromServer and toServer are from different NetBackup domains (media servers of different master servers):
Use the vssat command to set up trust between the master servers of fromServer and toServer. (See Changing a server across NetBackup domains. Refer to step 2 in the procedure.)
Add the master server of fromServer to the host properties Additional Servers list on toServer.
If fromServer or toServer are media servers:
Use the bpnbaz - ProvisionCert command to deploy the security (Machine) certificate if needed. ( See Connecting to a media server with Enhanced Auditing.)
Add the USER entry to the auth.conf file on each server.
If NBAC is enabled, run the nbsetconfig on each server to add the entry: USE_AUTH_CONF_NBAC = YES
To use the Remote Administration Console:
Set up trust with each master server by using either the vssat command or explicitly log on to each server at least once. (See Changing a server across NetBackup domains. Refer to step 2 in the procedure.)
To troubleshoot the configuration after setup, use nslookup and bptestnetconn -a -s to check server communications.