To replace a failed node on a UNIX or Linux cluster

1. Configure the hardware, system software, and cluster environment on the replacement node.
2. Verify that the device configuration matches that of the surviving nodes.
3. Ensure that the NetBackup Resource group is offline on all nodes before installing NetBackup on the replacement node.
4. Ensure that the NetBackup shared disks are not mounted on the node on which NetBackup is to be installed.
5. Freeze the NetBackup service.
6. Reinstall NetBackup on the new node or replacement node. Be sure to use the NetBackup Virtual Name as the name of the NetBackup server. Follow the instructions for installing the NetBackup server software.

   Refer to the NetBackup Installation Guide:

   http://www.veritas.com/docs/DOC5332

   Note:

   For the NetBackup Web Services, you must use the same user account and credentials that are used on the other nodes of the cluster. More information is available:

   http://www.veritas.com/docs/000081350

7. Install any Maintenance Packs and patches that are required to bring the newly installed node to the same patch level as the other cluster nodes.
8. Bring the NetBackup Resource group online on a node other than the freshly installed node.
9. Log onto the node on which the NetBackup resource group is online and run the following command:

   /usr/openv/netbackup/bin/cluster/cluster_config -s nbu -o 
   add_node -n node_name
   

   node_name is the name of the freshly installed node.

10. Switch the NetBackup resource group to the replacement node.
11. Freeze the NetBackup group.
12. Ensure that the appropriate low-level tape device and robotic control device configuration necessary for your operating system has been performed. Information is available for your operating system.

    Refer to the NetBackup Device Configuration Guide:

    http://www.veritas.com/docs/DOC5332

13. Run the Device Configuration Wizard to configure the devices. You do not have to rerun the device configuration on the pre-existing nodes. Configuration information on your particular cluster is available.

    See the NetBackup Administrator's Guide, Volume I:

    http://www.veritas.com/docs/DOC5332

14. Check that the robot numbers and robot drive numbers for each robot are consistent across all nodes of the cluster. Repeat for any other servers that are connected to that robot and correct if necessary.

    See the NetBackup Administrator's Guide , Volume 1:

    http://www.veritas.com/docs/DOC5332

15. Test the ability of NetBackup to perform restores using the configured devices on the replacement node.
16. Unfreeze the NetBackup resource group.