Software required to use NetApp Data ONTAP 7-Mode with Replication Director

Ransomware attackers specifically target and attempt to destroy backup systems to increase the probability of payment. Hardening your system is critical. Please ensure you have reviewed your platform security using the Security Hardening Checklist

Software required to use NetApp Data ONTAP 7-Mode with Replication Director — NetBackup 11.1 | Cohesity Documentation

NetBackup™ Replication Director Solutions Guide

The following NetApp software is required to use Replication Director.

Table: NetApp software required for Replication Director

Configuration	Applies to OCUM?	Primary storage system	Secondary storage systems
NetApp storage systems, FAS series Must be added to the OnCommand Unified Manager.	No	Yes	Yes
vFiler Can serve as a source only, not as a target. Enable if NDMP is used.	No	Enable	No
NDMP Enable on all storage systems, including vFiler. You can verify that the NDMP service is enabled with the following NetApp command: ndmpd status On the OnCommand Unified Manager, make sure that the NDMP Status is Up and that the NDMP credentials are Good.	No	Enable	Enable

Configuration

Applies to OCUM?

Primary storage system

Secondary storage systems

NetApp storage systems, FAS series

Must be added to the OnCommand Unified Manager.

Yes

vFiler

Can serve as a source only, not as a target. Enable if NDMP is used.

Enable

NDMP

Enable on all storage systems, including vFiler.

You can verify that the NDMP service is enabled with the following NetApp command:

ndmpd status

On the OnCommand Unified Manager, make sure that the NDMP Status is Up and that the NDMP credentials are Good.

Enable

Feedback

Was this page helpful?

Feedback

Was this page helpful?