Changing a retention period

Use the following procedure to change a retention period.

To change a retention period

On the left, select Hosts > Host properties.
Select the primary server.
If necessary, click Connect. Then click Actions > Edit primary server.
Click Retention periods.
Locate the retention level to change and click Edit.
By default, levels 9 through 100 (except level 25) are set to infinite. If the levels are left at the default, there is no difference between a retention level of 12 and a retention level of 20. Level 9 cannot be changed and the retention period is always set to infinite. Retention level 25 also cannot be changed and the retention period is always set to expires immediately.
NetBackup displays the names of all schedules that use the selected retention level as well as the policy to which each schedule belongs.
Type the new retention period in the Value box.
From the Units drop-down list, select a unit of measure (days, weeks, months, years, infinite, or expires immediately).
After you change the value or unit of measure, an asterisk (*) appears in the Changes pending column to indicate that the period was changed. NetBackup does not change the actual configuration until the administrator accepts or applies the changes.
Click Impact report.
The policy impact list displays the policies and the schedule names where the new retention period is less than the frequency period. To prevent a potential gap in backup coverage, redefine the retention period for the schedules or change the retention or frequency for the schedule.