UNIX device correlation example
On UNIX only.
Assume a TLD robot includes three drives and the operating system includes the following device paths:
|
Drive 1 |
/dev/rmt/0cbn |
|
Drive 2 |
/dev/rmt/1cbn |
|
Drive 3 |
/dev/rmt/3cbn |
Also assume that you requested that the tape be mounted on drive 1.
If the device path for the drive is configured correctly, the NetBackup Administration Console Device Monitor shows that the tape is mounted on drive 1.
If the Device Monitor shows that the tape is mounted on a different drive, the device path for that drive is not configured correctly. For example, if the Device Monitor shows that the tape is mounted on Drive 2, the device path for drive 1 is incorrect. Replace the drive 1 device path (/dev/rmt/0cbn) with the correct device path (/dev/rmt/1cbn) for drive 2. You may need to use a temporary device path while you make these changes. You also know that the device path for drive 2 is incorrect. Possibly, the device paths were swapped during configuration.
Use the robotic test utility to unload and unmount the tape from drive 1. Repeat the test for each drive.
If the path to the drive where the tape is mounted is not on the host with direct robotic control, you may have to unload the drive with a command from another host or from the drive's front panel.