The tpconfig device configuration utility attributes are as follows:

• Robot number

  You assign a robot number when you add a robot to the configuration. tpconfig prompts you to enter a number or accept the next available robot number that appears. This number identifies the robot in displays and listings, and it follows the robotic type in parentheses.

  If you configure robots on multiple systems, robot numbers must be unique. If you connect drives from a robot to multiple systems, specify the same robot number for the robot on all systems.

• Robotic control path

  For most robots, you or the operating system creates this path in the /dev directory when you add a robot to the configuration. When the tpconfig utility prompts you, enter the path to the robotic control as found in the /dev directory. If the entries do not exist, more information is available.

  See the NetBackup Device Configuration Guide, available at the following URL:

  https://support.cohesity.com/s/article/article-100040135

  The control path to a robot may be on another host. If so, enter the host name of the host instead of a path. When you define a robot that another host controls by another host, the robot number must be the same on both hosts.

  Information about how to configure robotic control is available.

  See the NetBackup Device Configuration Guide, available at the following URL:

  https://support.cohesity.com/s/article/article-100040135

• Host name

  You must specify a host name in the following cases:

  • When you add an ACS robot, enter the name of the host on which the ACS Library Software resides instead of a robotic control path.

  • When you add TLD robots that have robotic control on another host, you are prompted for the name of that host.

• No rewind on close device name

  You specify an no rewind on close device name when you add a drive. Usually the letter n precedes or follows the device name. If the device name entries do not exist, you must create them.

  See the NetBackup Device Configuration Guide, available at the following URL:

  https://support.cohesity.com/s/article/article-100040135

  In tpconfig displays and tpconfig output, the device names are shown under the heading DrivePath.

• Drive status

  Drive status indicates whether NetBackup considers a drive available. You specify the initial drive status when you add a drive to the configuration. You can change the status. To do so, use the Update option of the Drive Configuration menu in tpconfig (ensure that the device daemonltid is not active). If the device daemon ltid is active, use the Administration Console Device Monitor or the vmoprcmd command.