Configure FIPS mode in your NetBackup domain
This section provides steps to enable FIPS mode in your NetBackup domain. Before proceeding with the steps, ensure that the prerequisites are met in your environment.
See Prerequisites.
See About FIPS support in NetBackup.
You can configure FIPS mode on NetBackup during installation. Refer to the following topics:
You can configure FIPS mode on NetBackup after installation. Refer to the following topics:
Note:
Ensure that the required configuration steps are carried out on every NetBackup host as applicable.
Enable FIPS mode for each host in the NetBackup domain.
See Enable FIPS mode on a NetBackup host after installation.
You must carry out the following step if the host is a primary server:
You must enable FIPS mode for the NetBackup Authentication Broker (AT) by updating the VRTSatlocal.conf configuration file on the primary server.
See Enable FIPS mode for the NetBackup Authentication Broker service.
Enable FIPS mode for the NetBackup Administration Console.
See Enable FIPS mode for the NetBackup Administration Console.