Configuration requirements if using Change Server with NBAC
Additional configuration is required to perform the Change Server operation if NetBackup Access Control is used.
The following steps assume that NBAC is already configured.
Add fromServer to the host properties Additional Servers list on toServer.
If fromServer and toServer are from different NetBackup domains (media servers of different primary servers):
Use the vssat command to set up trust between the primary servers of fromServer and toServer.
Add the primary server of fromServer to the host properties Additional Servers list on toServer.
If fromServer or toServer are media servers:
Use the bpnbaz - ProvisionCert command to deploy the security (Machine) certificate if needed.
To use the auth.conf file:
Add the USER entry to the auth.conf file on each server.
If NBAC is enabled, run the nbsetconfig on each server to add the entry: USE_AUTH_CONF_NBAC = YES
To use the Remote Administration Console:
Set up trust with each primary server by using either the vssat command or explicitly log on to each server at least once.
To troubleshoot the configuration after setup, use nslookup and bptestnetconn -a -s to check server communications.