Monitoring Linux/UNIX disk load
You can use the iostat utility to check device I/O performance, such as average wait time and percentage of disk utilization.
Try the following:
iostat -ktxN 5
where 5 specifies a five-second refresh rate.
Sample output from the Red Hat 7 kernel:
iostat -ktxN 5
Time: 07:39:14 AM
avg-cpu: %user %nice %system %iowait %steal %idle
5.02 0.00 8.84 0.84 0.00 85.30
Device: rrqm/s wrqm/s r/s w/s rkB/s wkB/s avgrq-sz avgqu-sz await svctm %util
sda 0.00 .40 0.00 3.80 0.00 48.80 25.68 0.11 29.89 3.37 1.28
sdb 0.00 7.60 0.80 9.40 3.20 69.60 14.27 0.52 50.90 3.53 3.60
sys-r 0.00 0.00 0.00 2.00 0.00 8.00 8.00 0.02 10.80 2.40 0.48
sys-swap 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00
sys-usr 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00
sys-h 0.00 0.00 0.80 27.20 3.20 108.80 8.00 1.33 47.63 1.11 3.12
sdc 0.00 2.60 0.00 3.60 0.00 25.60 14.22 0.01 3.56 0.22 0.08
sdd 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00 0.00
Note:
This example is from a Red Hat 7 Linux system. Other operating systems may use different options. Refer to the iostat man page of each OS for details.
Helpful report values are the following:
await: The average time (in milliseconds) for device I/O requests to complete, for both the virtual device and the physical disk. This includes the time the requests spend waiting in the disk queue and the time servicing them. In general, low average wait values indicate better throughput.
%util: The percentage of elapsed time in which I/O requests were sent to the device. As the value approaches 100%, saturation of the device occurs. A lower percentage is better.
If NetBackup is running on Red Hat 8 Linux and the storage manager InfoScale is used for MSDP storage management, you may find the VxVM devices name no longer appear in the iostat output. You can check the VxVM IO mode with the command vxtune vol_use_rq. If the current value of vol_use_rq is '0', then BIO mode is enabled. Otherwise, Request mode is enabled. The mode change is needed to bypass a known Red Hat 8 Linux bug. In order to analyze IO statistics for VxVM devices when BIO mode is enabled, use vxstat instead of iostat.