Performing steps after volume restore containing LVM
You can perform steps after volume restore for the LVM volumes.
Note:
SFR (Single File Restore) or GRT (Granule Restore) and application restore are performed through the installed agents. However, for volume recovery, it is necessary to make the associated file systems online after successful recovery.
To perform steps after volume restore
- Run the command to see all newly attached post volumes on to the host PV's.
If there are duplicate PVs (a warning is displayed on the above command) then run,
vgimportclone --import /dev/<Device1> /dev/<Device2> ... --basevgname <NewVGName>
Otherwise, find out the newly created Volume Groups (VG) on the host. If new VGs are not displayed then import the VG using the following command. It discovers new VG as <NewVGName>
vgimport -a
vgs
- Run this command to list all the logical volumes (new and old):
lvs <NewVGName>
- Activate all the LVs belonging to <NewVGName> as,
lvchange --activate y /dev/mapper/<NewVGName>-<LVName1>
lvchange --activate y /dev/mapper/<NewVGName>-<LVName2>
lvchange --activate y /dev/mapper/<NewVGName>-<LVNameN>
- Identify the UUID and file system of an authenticated and newly activated LV.
blkid -p /dev/mapper/<NewVGName>-<LVName1>
Output: /dev/mapper/<NewVGName>-<LVName1>: UUID="2a4bdc14-b5eb-4ee6-b876-ebdcb66c55d9" BLOCK_SIZE="4096"TYPE="xfs" USAGE="filesystem"
blkid -p /dev/mapper/<OldVGName>-<LVName1>
Output: /dev/mapper/<OldVGName>-<LVName1>: UUID="2a4bdc14-b5eb-4ee6-b876-ebdcb66c55d9" BLOCK_SIZE="4096"TYPE="xfs" USAGE="filesystem"
- If the UUID is the same, then you need to change it as follows
File System
Steps
xfs
mkdir <NewMountPoint>mount -o nouuid /dev/mapper/<NewVGName>-<LVName1> <NewMountPoint>umount <NewMountPoint>xfs_admin -U generate /dev/mapper/<NewVGName>-<LVName1>mount /dev/mapper/<NewVGName>-<LVName1> <NewMountPoint>ext2 / ext3/ ext4
mkdir<NewMountPoint>tune2fs -U random /dev/mapper/<NewVGName>-<LVName1>mount /dev/mapper/<NewVGName>-<LVName1> <NewMountPoint> - If the UUID is different, then run the following command.
mount /dev/mapper/<NewVGName>-<LVName1> <NewMountPoint>