Restoring an AIX client with media boot
Note:
Review the secure communication compatibility support matrix for BMR table to know more about the supported master, boot server, client, and SRT versions for Linux, Windows, Solaris, AIX, and HP-UX environments. See Secure communication compatibility matrices for BMR for NetBackup 8.1.1 and later releases.
Note:
If NetBackup access management is used in your environment, you must provide the appropriate credentials when prompted so that NetBackup can restore the client files.
An AIX boot (either network boot or media boot) may set the network interface configuration, speed, and duplex mode to auto-negotiate or 10 half duplex. This setting may cause the BMR restore to run much more slowly than expected. To achieve normal restore performance, manually set the network interface configuration through the firmware before a BMR restore.
To restore an AIX client with media boot
- Prepare to restore the client using the SRT you created on the bootable media.
- Boot the client from the boot media you created. For instructions on how to boot from a CD or from a DVD, see the IBM hardware documentation.
- Due to the automatic recovery parameter set during prepare to restore, the restore operation attempts to retrieve the host-ID based certificate and validate the Certificate Authority (CA) certificate. This recovery is time bound. For more information about the automatic recovery during prepare to restore, See Preparing a client for restore.
Enter the required information at the following BMR process prompts:
Client name (for a discovery boot, enter the client's name as it appears in the Tasks view from the prepare-to-discover operation)
Client IP address
Network mask
Default gateway
NetBackup master server name
NetBackup master server IP address
NetBackup master server gateway IP address
The restore begins.
Note:
If you abort the restore operation or if the restore operation fails, either run the prepare to restore operation again to restart the automatic recovery or manually set the Allow Auto Reissue Certificate option using the NetBackup Administration Console or command-line interface.
For more information about manually setting the Allow Auto Reissue Certificate option, see Allowing automatic reissue of a certificate section within the NetBackup Security and Encryption Guide
After a successful completion of restore, the host ID-based certificate is copied on the client that is restored. The automatic recovery parameter is reset. For more information about the automatic recovery, See Preparing a client for restore.
More Information