Removing an MSDP load balancing server
You can remove a load balancing server from a deduplication node. The media server no longer deduplicates client data.
See About MSDP storage servers.
After you remove the load balancing server, restart the NetBackup Enterprise Media Manager service. The NetBackup disk polling service may try to use the removed server to query for disk status. Because the server is no longer a load balancing server, it cannot query the disk storage. Consequently, NetBackup may mark the disk volume as DOWN. When the EMM service restarts, it chooses a different deduplication server to monitor the disk storage.
If the host failed and is unavailable, you can use the tpconfig device configuration utility in menu mode to delete the server. However, you must run the tpconfig utility on a UNIX or Linux NetBackup server.
For procedures, see NetBackup Administrator's Guide, Volume II:
http://www.veritas.com/docs/DOC5332
To remove a media server from a MSDP node
- For every storage unit that specifies the media server in Use one of the following media servers, clear the check box that specifies the media server.
This step is not required if the storage unit is configured to use any available media server.
- In the NetBackup Administration Console, expand Media and Device Management > Credentials > Storage Server.
- Select the deduplication storage server, and then select Edit > Change.
- In the Change Storage Server dialog box, select the Media Servers tab.
- Clear the check box of the media server you want to remove.
- Click OK.
