File restore job fails with an error message
The file restore job fails with the following error message in the job monitor:
Unable to detect volume for disk <disk_name>
check if there is any network devise attached to the host, detach If exists. 2 open the command prompt in admin privileges. 3. run the command: diskpart 4. inside diskpart prompt type "rescan" and enter 5. exit the diskpart prompt and command line. 6. try restore again
To resolve this issue, perform the following:
If any network device is attached to the device, detach it.
Open the command prompt in admin privileges and run the following command:
diskpart
Inside the diskpart prompt, type rescan and press enter.
Exit the diskpart prompt and the command line.
Perform the file restore operation again.