Replacing a failed node on a Windows VCS cluster
Cluster technology-specific information is available about how to bring the NetBackup resource group online and offline. Also, it is available on how to freeze and unfreeze (disable and enable the monitoring for) the resource group.
Refer to topics about configuring NetBackup in the NetBackup High Availability Guide:
http://www.veritas.com/docs/DOC5332
Check the following conditions before you proceed with this procedure:
The hardware, system software, and cluster environment on the replacement node have been configured.
The reconfigured node or replacement node has been made a member of the cluster and has the same name as the failed node.
The following procedure applies when the shared disk and at least one configured cluster node remain available.
To replace a failed node on a Windows cluster using VCS
- Freeze the NetBackup service.
- Ensure that the NetBackup shared disks are not mounted on the node on which NetBackup is to be installed.
- Reinstall NetBackup on the new node or replacement node. Be sure to use the NetBackup Virtual Name as the name of the NetBackup server. Follow the instructions for installing the NetBackup server software.
Refer to the NetBackup Installation Guide:
- Ensure that the node is a member of an existing cluster and that it performs the necessary configuration automatically.
- Install any Maintenance Packs and patches that are required to bring the newly installed node to the same patch level as the other cluster nodes.
- Unfreeze the NetBackup service and verify that it can be brought up on the replacement node.