Managing continuous replication
You can manage continuous replication by Replication> continuous start, Replication> continuous stop, Replication> continuous pause and Replication> continuous resume commands. It is recommended that you should run all these commands from the source cluster.
To start data replication
- To start data replication, enter the following command:
Replication> continuous start fs_name
fs_name
Specify the file system name that you have configured for continuous replication.
The data replication between source cluster and destination cluster starts.
To pause data replication
- To pause data replication, enter the following command:
Replication> continuous pause fs_name
fs_name
Specify the file system name that you have configured for continuous replication.
The data replication between source cluster and destination cluster is paused.
To resume data replication
- To resume data replication, enter the following command:
Replication> continuous resume fs_name
fs_name
Specify the file system name that you have configured for continuous replication.
The data replication between the source cluster and the destination cluster which was paused is resumed.
To stop data replication
- To stop data replication, enter the following command:
Replication> continuous stop fs_name
fs_name
Specify the file system name that you have configured for continuous replication.
The data replication between source cluster and destination cluster is stopped.
Note:
Veritas recommends that you should run replication continuous resume command when replication is in paused state. You should run Replication> continuous stop command when replication is in progress.