Enabling STIG using the command-line interface

Use the following commands to enable STIG from the command-line interface.

Log on to the Access command-line interface by opening an SSH session to the management console IP as an administrator.
In the Access command-line interface, run the following command:
system
Type the following command:
System> security stig
The enable, show, and precheck options are displayed.
To run the precheck, enter the following command:
System> security stig precheck
```
NTP Check : PASS

Email Check : PASS

DNS Check : PASS

FTP check : PASS
```
To enable STIG on both the nodes:
System> security stig enable