To set up the episodic replication job

1. To create an episodic replication job, enter the following:

   Replication> episodic job create job_name src_repunit tgt_repunit
   link_name schedule_name [evpsn] [metadata_only]

   job_name	Specify a name for the episodic replication job you want to create.
   src_repunit	Specify the source episodic replication unit. The episodic replication unit determines the exact item (such as a file system) that you want to replicate.
   tgt_repunit	Specify target episodic replication units.
   link_name	Specify the link name used when you ran the Replication> episodic config auth command between the local cluster and the remote cluster. Both the source cluster and the destination cluster need to be assigned a unique identifier (name). This identifier is used to identify the link that is established between the source and the destination clusters. You can use the link name instead of the virtual IP addresses of the source and the destination clusters when using the other episodic replication commands.
   schedule_name	Specify the name of the episodic replication schedule you want to apply to the episodic replication job.
   evpsn	Enable or disable Enterprise Vault partition secure notifications.
   metadata_only	Enable or disable metadata-only episodic replication. This feature is not supported with consistency groups and tunables.

2. To add an excluding unit to the job, enter the following command. This step is optional.

   Replication> episodic job exclude job_name exclunit_name

3. By default, the job is disabled. To enable the job, enter the following:

   Replication> episodic job enable job_name

4. To check if the job was enabled, enter the following:

   Replication> episodic job show [job_name]